Contact and support: noiseblaster@me.com

 
The Colors mode allows you to adjust brightness and contrast. The Exposure slider controls the illumination of the image. Slide it to the right to increase brightness or to the left to decrease it. Slide the Contrast slider to the right in order to enhance contrast or to the left in order to decrease it.
 
The Settings screen determines the resolution in which the photo will be saved. You can choose one of the resolutions in the list. The photo will not be saved in a higher resolution then its original resolution, even if you have marked a higher resolution. Notice that the higher the resolution the longer the saving process. The resolution you have chosen will be used as default until you change it.
 
The Denoise mode enables you to reduce noise in your photo. Once you enter the Denoise mode the photo is zoomed in to for an ultimate view of the noise. At this point you can't zoom in and out. Random color fragments that make the surface color look uneven or tainted can be eliminated by sliding the Denoise bar to the right. You can move the photo around to see a preview for each section of the image. Manual control of the slider helps you achieve a desired balanced result.

Don't administer the filter too strongly in order to prevent the colors from becoming faded or dull.

Choose to apply the filter once you are satisfied – noise reduction will be executed only after you press the Apply button.


If you change your mind about the degree of noise reduction you applied, choose the Denoise mode again. The before side (left side) shows the original photo and the preview side (right side) shows the denoising amount you last applied. The filter will be administered on the original photo.

 

Too little noise reduction

Too much noise reduction

Once you are ready to save press the Done icon. A new screen will open where you can press the Save button (the photo will be saved to the Camera roll / Saved photo library depending on your device). You can also choose to edit another photo by clicking the Edit existing photo button. If you are an iPhone user press the Take a photo button to shoot a new picture directly from the application.